15 May 2008, 13:17
Hi
is this normal.
took pistons out, fully cleaned them. bit of crud behind.
so left the middle seal inplace (were rebuilt 6 months ago)
put new fluid on the piston, slid into place but had to use a spanner across the top and put a fair bit of weight to force the piston down.
the second one went better, slid slowly then shot in.
is this normal, or are these too stiff?.
thanx
is this normal.
took pistons out, fully cleaned them. bit of crud behind.
so left the middle seal inplace (were rebuilt 6 months ago)
put new fluid on the piston, slid into place but had to use a spanner across the top and put a fair bit of weight to force the piston down.
the second one went better, slid slowly then shot in.
is this normal, or are these too stiff?.
thanx
Steve Saunders
Wolverhampton
ex owner vin 1621
doc 370
Wolverhampton
ex owner vin 1621
doc 370