The DeLorean Owners Club UK Forum

Hi All

Vin 1621 back on the road again with a rebuilt front caliper. did it myself to make sure of a good job!.

now the indicators have packed in. occassionally work, but most of the time nothing..no click etc.

but the hazards work fine.

do these feed through the same earth?.

i know first will be the fuse to see if its ok or dirty contacts. next the column connection and switchgear.

anyone else had this fault?

Check the electrical connector block is correctly seated on the back of the hazard warning switch matey.

hi

mine does the same its ullsay a dry joint in the relay box behind the dash in the driver side i have done mine 3 times know but i going to buy a new one

thanx all will check

is it like an mx5 i had...if you remove the hazard switch then the indicators were dead....it seemed to take a feed of this switch.

just wondered if the D is the same?.

Regards

yep its works i think the same way as i can remember doing it to mine when ikind of had a melt down poblem with mine :roll: